您好,欢迎访问济南潇蔚商贸有限公司!济南彩钢,济南彩钢板房,济南活动板房,济南工程板房等!

全国服务热线

13553164852

热门关键词:济南彩钢 济南彩钢板房 济南活动板房 济南工程板房 彩钢板房
当前位置:首页>新闻资讯>新闻动态>济南彩钢房设计应该注意什么?

济南彩钢房设计应该注意什么?

来源:http://www.lxcaigang.com 日期:2020-07-22 发布人:admin
活动板房因为独特的优势被大量应用,那么对于济南活动板房的设计应该注意什么
Because of its unique advantages, the movable plank house is widely used. What should be paid attention to in the design of Jinan mobile board house
一、要注意防腐
1、 Pay attention to anticorrosion
活动板房一年四季要接受阳光风雨,而且自然界中的氧气还有水分会对活动板房造成腐蚀,尤其是空气中的二氧化硫,腐蚀性更严重。因此在设计活动板房的时候要考虑防腐,目前防腐更主要的方法就是使用保护层,喷上防锈漆。
The movable plank house has to accept the sunshine and wind and rain all the year round, and the oxygen and moisture in the nature will cause corrosion to the prefabricated house, especially the sulfur dioxide in the air, which is more corrosive. Therefore, anticorrosion should be considered in the design of prefabricated house. At present, the main method of anti-corrosion is to use protective layer and spray antirust paint.
二、节点附近构件的变化
2、 Change of components near nodes
在设计活动板房的时候还要考虑在节点附近构件的变化,尤其是在一些主要的节点,不然会影响到整个活动房的结构,经过一系列的研究表明更好的连接方式就是接近铰接,这样受力才比较均匀,而且也更加坚固。
In the design of prefabricated house, the change of components near the nodes should be considered, especially in some main joints, otherwise the structure of the whole movable house will be affected. After a series of studies, it is shown that the best connection method is close to the hinge joint, so that the stress is more uniform and stronger.
三、变形限制
3、 Deformation limitation
活动板房在实际的生产、运输以及拆卸的过程中,肯定会发生变形之类的,变形之后如果我们没有进行检测,之后再次安装的就会出现问题,因此在设计的时候我们首先要规定能接受的变形限制,来保证结构的安全。
In the process of actual production, transportation and dismantling, the movable plank house will certainly deform. If we do not carry out the inspection after deformation, problems will appear in the installation again. Therefore, when designing, we should first stipulate the acceptable deformation limit to ensure the safety of the structure.
四、注意安装彩钢房周边环境
4、 Pay attention to the surrounding environment of color steel room
活动板房在安装的时候要注意安装的周边环境是不是合适,如果有两层要注意两层之间需要进行埋件焊接,安装要根据设计要求来,不能出现漏焊或者假焊的情况。
During the installation of the prefabricated house, attention should be paid to whether the surrounding environment is suitable. If there are two floors, it is necessary to pay attention to the welding of embedded parts between the two layers. The installation should be based on the design requirements, and there should be no missing welding or false welding.
五、不能够漏水
5、 It can't leak
如果是高空作业,那安装的时候一定需要戴安全装置。做好防腐处理和排水处理,不能出现漏水的情况。
If it is high-altitude operation, it must wear safety devices when installing. Do a good job in anti-corrosion treatment and drainage treatment, no water leakage.

联系人:苗经理

联系电话:15154179985

咨询热线:13553164852(微信同号)

地址:济南市历城区旅游路888号

流量统计:

微信二维码

微信二维码