1、货物运输车辆类型的选择。一般采用大型专用拖车运输，应根据彩钢板的规格选择合适的运输车型。

1. Selection of vehicle types for cargo transportation. Generally, large specialized trailers are used for transportation, and suitable transportation models should be selected based on the specifications of color steel plates.

2、装彩钢板时，发动机舱面板及附件要按型号预装，绑扎牢固，防止金属面脱落。

2. When installing colored steel plates, the engine compartment panel and accessories should be pre installed according to the model, securely tied to prevent the metal surface from falling off.

3、运输时，应将彩钢板牢固地固定在车上，并采用木楔等临时固定措施，避免因车身晃动而松动。挤压以减少彩钢板的磨损或擦伤。注意运输板的高度是否超过拖车长度，并采取相应措施防止车辆侧翻。长途运输或路况较差时，彩钢板应水平放置。

3. During transportation, the color steel plate should be firmly fixed on the vehicle and temporary fixing measures such as wooden wedges should be used to avoid loosening due to vehicle shaking. Squeeze to reduce wear or scratches on the color steel plate. Pay attention to whether the height of the transport board exceeds the length of the trailer, and take corresponding measures to prevent the vehicle from tipping over. During long-distance transportation or poor road conditions, color steel plates should be placed horizontally.

4、彩钢板作为专用墙板时，墙体支点长度不得大于1.0米，以保证材料不变形、不磨损。如果超过2米的面板，就要挑出相应的墙板固定在后面，以免撞到车尾，造成墙板变形过大，损坏彩钢板。搬运彩钢板时，两端同时抬起，以免损伤掩膜或涂层。

4. When using color steel plates as specialized wall panels, the length of the wall support point should not exceed 1.0 meter to ensure that the material does not deform or wear. If the panel exceeds 2 meters, the corresponding wall panel should be removed and fixed at the back to avoid colliding with the rear of the car, causing excessive deformation of the wall panel and damage to the color steel plate. When handling color steel plates, lift both ends simultaneously to avoid damaging the mask or coating.